How to troubleshoot the error of the start-up in HP computer with windows 7, 8 and 10?

Often, HP users face start up error in their computers. There may be a lot of reasons which cause this error in HP computers such as severe hardware errors which display in the form of no powering up, uncommon beep or strange sound from the hard drive. These errors may arise due to no spinning of fans and blinking of the power button.

Important instructions to fix the error of the startup in HP computer with windows 7, 8 and 10:-


Step 1:- Need to Reset HP BIOS: -

The first thing needed to be done is to unplug all the external devices whether it is the printer, thumb drive or hard drive or anything connected to it. If still this error continues, then users need to check If BIOS is configured in the wrong ways. Users need to go to the start-up screen and then press F10 option to go to the BIOS set up screen. If still the error is not resolved, then you need to scroll down to BIOS reset button in the menus bar. When you are completed with this, you need to press F10 button again to save and then exit. Your computer system will begin to boot without any error. If you are unable to do this, you can take help from technical experts through toll free HP support phone number 1-866-505-7911 within few seconds.


Step 2:- Giving No Power to HP computer system:-

If your HP computer system is displaying zero power with few lights and fans working while others do not or the computer is in the dead state, it will be very helpful. Ordinarily HP computers have LED light in the reverse, which you have to long press after unplugging the power for minimum 20 seconds. It is very necessary to drain stored power in the capacitors of the motherboard. After that, you need to plug in the computer system and power it back as advised by HP computer technical support team. Check carefully if LED light is ON and yet now, there is no power access, then check immediately if the Motherboard power is displaying green. If LED in on, then there is Motherboard behind this error.


Step 3:- Apply “Factory Reset” option-

If error is with software, then users must try to boot into safe mode just by pressing F8 key immediately. Remove latest installed software or drivers. This procedure is very useful if the users are aware of the reason behind the error. 


Resources URL :


Share This Story

Get our newsletter